Have questions?  Call: 626-303-5676
24/7 Repair & Service  1-866-751-7378

Amada Miyachi Blog

PCBs: Design Tips for Successful Hot Bar Reflow Soldering

Posted by Paul Brackell on Thu, May 30, 2013 @ 08:17 PM

Most PCB materials like FR2 and FR4 are very resilient to the application of heat during the hot bar reflow soldering (or hot bar bonding) process. But some materials - ceramic substrates in particular - need to be heated in a more controlled fashion to minimize the chance of cracking. Excessive differences in the heat sinking capability of the two parts being joined can also cause solder cracking during cooling.  Heat sinking differentials along the solder joint length are the most common design problem to overcome. Small differences may not have much effect on quality, but any large thermal mass change along the joint area will cause inconsistency of temperature and result in a poor solder joint.

Read More

Topics: hot bar reflow soldering, reflow soldering, hot bar soldering

Flexible Circuit Design: 3 Layouts for Hot Bar Reflow Soldering

Posted by Barbara Kuntz on Thu, Apr 26, 2012 @ 01:17 PM

Flexible circuits are found everywhere: cell phones, tablets, flat screen tvs, cameras, rockets, satellites – anywhere electrical connections are required in three or more axes; where the assembly is required to flex during operation; where weight is an issue; and, as devices get smaller and smaller - where board thickness or space is a driving factor.  They are most often connected using hot bar reflow soldering which utilizes a thermode heating element and allows for a more repeatable and consistent joint quality than traditional hand soldering, and are commonly made of two layers of polyimide encapsulating copper traces.  Copper trace thickness generally ranges from 0.0007 – 0.004 inches, and thickness of the flex is between 0.001 – 0.0047 inches.

Read More

Topics: hot bar reflow soldering, reflow soldering, hot bar soldering

Subscribe to Email Updates

Recent Posts

Posts by Topic

see all

Follow Me